Quartus Prime 18.13/25/2021
Respective University constituents are responsible for reviewing and maintaining up to date information.Links and all references to outside content do not constitute (i) incorporation by reference of information contained on or in such outside content and such information should not be considered part of U.OSU.EDU or (ii) endorsement of such content by The Ohio State University.Quartus Prime EDA Netlist writer was unsuccessful.
Quartus Prime Full Compilation was unsuccessful. Error: Peak virtual memory: 4674 megabytes Error: Processing ended: Sun Dec 30 15:50:33 2018 Error: Elapsed time: 00:00:05 Error: Total CPU time (on all processors): 00:00:05. But the Makeimage.py generates an output file FPGAImageRLE.h that is 0KB in size. Quartus Prime 18.1 Code Is LookingIs the header part of SVF critical as it says SDR 5748760 TDI but the python code is looking for if (s0:17 SDR 4087056 TDI (): Thanks for your rapid replies. Compile of Arduino has stalled so will look at that tomorrow. HNY.On 31 December 2018 at 21:21 Giako68 wrote: You probably modified the project target. Make sure it is the 10CL016YU256C8G chip and rebuild it.You are receiving this because you authored the thread.Reply to this email directly, view it on GitHub, or mute the thread. Is that critical Sadly I cannot find the boxmenu to select that, or rather I may have seen it over the last few days but cannot remember where. To solve the problem you should modify the script in Python, but on this I can not help you since I do not use Windows for many years. Exactly what error do you have when compiling in Arduino IDE. With your header file linked in the HDMI display comes up and over a few seconds the text is displayed on the screen, but with my header there is no HDMI output at all. Red LED comes on after about 30 seconds, same as with your code. This mornings attempt to put Ubuntu 16.04-04 on my i386 laptop failed. It now refuses to boot up which I suspect is because of the defective WiFi driver. And Im not entirely sure if 18.1 will run in 32-bit mode anyway.conflicting info on Intels site about that. Will report back my findings with 18.0 soon. In fact all my attempts to use 18.1 on the GitHub Vidor FPGA projects have ended in failure so trying 18.0 could be interesting. You will be very pleased to hear that 18.0 seems to generate a working header file;-). BTW I used its programmer menu to generate the.svf file (1012kb) at 25MHz. The python file skipped the quartuscpf.exe bit ( files not found, etc, typical Windows issue) but the RLE section happily converted.svf to.h (686kb). It therefore seems that on Linux there are no problems with 18.1.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |